Yard Insight
Planters, Raised Beds & Greenhouses

Lean-To vs Freestanding Greenhouse: Which Wall?

Published · Updated

This post may contain affiliate links. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure

In the lean to vs freestanding greenhouse decision, the wall decides it. A lean-to works when it is attached to a wall that faces roughly south, because Washington State University Extension's guidance is that an attached greenhouse should ideally connect on "the south-facing side," and the worst site for any greenhouse is on the north side of something that casts a shadow. If your only available wall faces north, or the house shades the spot by early afternoon, build freestanding. Attaching saves a wall and shortens the run for power and water. It never buys back lost light.

Why the wall, and not the price, is the first question

A freestanding greenhouse takes light from every direction and from sunrise to sunset. A lean-to has given one side away permanently, so everything depends on which side that is and what the house does to the sun for the rest of the day.

WSU Extension's greenhouse construction chapter sets out the siting rule without reference to greenhouse type: "The best location for a greenhouse structure is on the south or southeast side of anything that might cast a shadow on it," and "The least desirable site for a greenhouse is on the north side of anything that casts a shadow on the greenhouse." It also makes the point that matters most for an attached design, that attached greenhouses "may experience shading from the adjacent structure." The house is not just a wall you get for free. It is also the tallest shadow-caster on the site.

Winter is when this bites. WSU's reminder is that "In winter, the sun is lower and shadows are longer than in the summer," and winter is the season a greenhouse is supposed to be earning its keep. A spot that looks sunny in July can sit in house shadow from two in the afternoon in December.

Ranking your walls

Ranking your walls

Go outside and look at the actual wall rather than at the floor plan.

Wall aspect What a lean-to there gives you
South The reference case. Full day light, and the wall behind the glazing is in sun rather than casting shade over it.
Southeast Strong morning light, earlier warm-up, shade arriving later in the day.
Southwest Afternoon light, a slower start on cold mornings.
East or west Half a day of direct sun and half a day in the building's shadow. Workable for hardening off and overwintering, limited for winter growing.
North Avoid. This is WSU's least desirable site stated as a floor plan.

Two further checks before you commit to a wall:

  • What else shades it? A fence, a neighbor's garage, an evergreen hedge or a chimney can take the sun off a south wall for part of the day. Stand in the spot at midday in winter, not in summer.
  • What is on the wall? Downpipes, gas meters, dryer vents, outside taps, electrical meters, boiler flues and service access all have to stay reachable, and a flue or combustion appliance vent must never be enclosed or obstructed by a new structure. If a flue discharges into the space you are planning to build, that wall is out.

What a lean-to genuinely gives you

Shorter runs for everything. WSU notes the practical advantage plainly: "utilities like electric and water can be utilized from the existing building." A tap and a weatherproof outlet a few feet away is a real saving against trenching across a lawn.

One less wall to lose heat through, and a wall that stores heat. A masonry wall warmed by the sun during the day gives some of that heat back at night. How much depends on the wall's material, color, thickness and how much sun it actually gets, so treat it as a benefit worth having rather than a number you can plan around. Anyone quoting you a specific temperature gain for your wall is guessing.

Footprint. A lean-to fits a narrow strip along a house where a freestanding structure would not fit at all, and it is often the only way a small yard gets a greenhouse.

Access in bad weather. A door you can reach without crossing a wet lawn in January is the reason many lean-to owners say they use theirs more.

What a freestanding greenhouse gives you

What a freestanding greenhouse gives you

Light from every side, and free choice of orientation. With no wall attached, you can place it where the sun is rather than where the house is. The Royal Horticultural Society's greenhouse guidance adds a useful nuance on which way to point it: "An east-west orientation will slightly extend light levels during winter. A north-south orientation is suited to summer crops such as tomatoes, with both sides receiving several hours' sun from the east and the west." You choose by season, not by what the house allows.

Ridge vents on both sides. A lean-to has one roof slope and one wall where a ridge used to be, which limits how much high-level vent area you can fit. Ventilation is sized by opening area, and the lean-to starts that calculation at a disadvantage.

Nothing attached to your house. No flashing, no fixings into the wall, no new path for water or damp against the building, and nothing to undo when you sell.

You can move it. Within reason, a freestanding kit on a gravel pad is relocatable. A lean-to is part of the house until somebody takes it off.

The cost nobody prices: attaching to the building

The cost nobody prices: attaching to the building

This is the part the comparison pages skip, and it is the reason a "free" wall is not free.

A lean-to is a structure fixed to your home's weather envelope. The junction between its roof and the house wall has to be flashed so that water runs out and not in, every fastener into the wall is a hole in that envelope, and the wall behind warm humid air is now a wall that can collect condensation. Moisture that cannot get out collects on the coldest surface it can find, which is the same process that produces condensation in a metal or resin shed, except that here the cold surface may be part of your house.

Three rules keep this sane:

  1. Treat flashing and wall fixings as building work. Fixing into brick, block, timber framing or siding, and making the roof junction watertight, is work for a contractor if you are not certain what is behind the surface and how to seal it. Drilling into a wall blind also risks buried cables and pipes: locate services before any hole goes in.
  2. Ask about permits before you buy. An attached structure is more likely to be regulated than a detached one of the same size, and homeowners associations have their own say. Expect the answer to vary by town, the same way the answer to whether a fire pit needs a permit does.
  3. Build the base properly either way. Both types need a level, draining, anchorable base, and the choice between gravel, pavers and concrete follows the same logic as the base under a shed.

Lean to vs freestanding greenhouse: how to decide in five minutes

Lean to vs freestanding greenhouse: how to decide in five minutes
  • No south, southeast or southwest wall available, or the house shades the spot by mid-afternoon in winter: freestanding.
  • Narrow yard, sunny wall, and you want to walk out of the kitchen into it: lean-to.
  • You want maximum light for winter crops and you have open ground: freestanding, oriented east to west.
  • You are renting, or you expect to move the structure: freestanding.
  • You are confident about flashing, fixings and your local permit position, and the wall faces the sun: lean-to, and have the attachment detailed properly.

Frequently asked questions

Which wall should a lean-to greenhouse go on?

A wall facing roughly south, in the northern hemisphere. WSU Extension says an attached greenhouse should ideally connect to the south-facing side of the building, and that the least desirable greenhouse site is on the north side of anything that casts a shadow. Southeast and southwest walls both work, with the trade being morning light against afternoon light.

Is a lean-to greenhouse warmer than a freestanding one?

It has two advantages that point that way: one fewer exposed wall, and a masonry wall that absorbs sun during the day. How much warmer depends on the wall and the sun it receives, so there is no universal figure. A lean-to on a shaded or north-facing wall gets neither benefit.

Do lean-to greenhouses get enough light?

On a sunny wall, yes, for hardening off, overwintering and propagation. For winter crops that want every available hour of low sun, a freestanding greenhouse oriented east to west collects more, because the RHS notes that orientation slightly extends winter light levels.

Does attaching a greenhouse to the house cause damp?

It can if the junction is not detailed correctly. The roof-to-wall flashing has to shed water away from the building, fixings have to be sealed, and the greenhouse itself needs enough ventilation that humid air is not held against the wall. Get the attachment detail done by someone who does flashing for a living if you are unsure.

Is a lean-to greenhouse cheaper than a freestanding one?

Usually on the kit itself, since there is one fewer wall of glazing and frame. The gap narrows once you add flashing, wall fixings, any permit, and the possibility of having the attachment done professionally. Price the finished installation, not the box.